Checking glass alignment
1. Check for abnormal noise or distortion during operation.
2. With the hatch closed, check for water leaks.
3. The glass seal (B) should be flush with the roof panel (A) within the standard dimension "E" all around. If not, make adjustments.
Note:
Standard value of "E":
Leading edge: 1.2 mm
Back edge: 1.0 mm
4. If the glass position is not as per specification, adjust it by loosening the adjusting screws (A) and then tightening them.
(Material was obtained from an official resource: «HYUNDAIBOOK.RU»)
