Contents: Adjusting the glass position ⇓ Adjusting the position of the door…⇓ Adjusting the door position ⇓
Adjusting the glass position
Note: Inspect the glass guide grooves for damage or wear and replace if necessary.
1. Remove the door trim.
2. Remove the door gasket.
3. Carefully move the glass (A) until the bolts appear, then release them. Remove the glass from the guide and from the window opening.
4. Make sure the glass moves smoothly.
5. Raise the glass fully and check the gaps.
Make sure the glass is in even contact with the guide channel.
Adjusting the position of the door lock hinge
See section "Adjusting the position of the door lock hinge" for the front door.
Adjusting the door position
Note: After installing the door, make sure it is flush with the body surface, then check the uniformity of the gaps between the door edges and the body along the entire perimeter of the door. Check the parallelism of the door edges and the body. Replace the mounting bolts before adjusting.
1. Place the vehicle on a level, horizontal surface when adjusting the door position.
The original can be found on the resource: HyundaiBook
2. Check the parallelism of the door and body edges.
3. Adjust the hinges (A):
A. Loosen the door mounting bolts slightly and move the door in and out until it is flush with the body.
B. Loosen the hinge bolts slightly and move the door back and forth, up and down, until the gaps on both sides are equal.
C. To avoid damaging the door while adjusting it, place a cleaning cloth on the jack.
Note: Tightening torque:
- (B): 34.3 - 41.2 Nm.
- (C): 9.8 - 19.6 Nm.
4. Lubricate the rubbing parts of the hinges in the indicated places.
5. Check the door for water leaks.