1. Rear bumper assembly
2. Bumper bracket
Replacement
Note:
To avoid damage when using a flat-blade screwdriver as a lever, wrap the screwdriver with electrical tape. Wear gloves to protect your hands from injury.
Be careful not to damage the bumper and other components.
1. Loosen the mounting screws and remove the rear combination lamp (A).
2. Press the lock pin and disconnect the connector (IN).
3. Turn away screws of fastening of lateral parts of a back bumper, then disconnect clamps and lateral parts.
4. Loosen the mounting bolts.
5. Press the lock pin and disconnect the main connector (IN) rear bumper.
6. Turn away fastening screws and remove clamps, then remove a back bumper (A).
7. Installation is carried out in the reverse order.
Note:
Make sure the connector is connected correctly.
Replace any damaged fasteners.