Testing power relays (Hyundai Tucson JM)

Check the continuity of the power relay circuit. The circuit should be continuous between pin 1 and pin 2 when power and ground are connected to pin 4 and pin 3. When power is disconnected, the circuit should be open.

The full version is located on the website (HyundaiBook.ru)

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This article has been reviewed by: Konstantin Smirnov

Add to social network:

Tucson 1: Equipment and devices

Fuses and relays — device
Schematic diagram of the alarm system
Central locking and alarm — technical condition check
Checking the alarm module
Central locking and alarm — general information

Instrument panel — schematic diagram
Instrument panel — removal and installation
Instrument panel — checking the technical condition
Mirror system
Lighting system — device

We recommend other articles on the topic of Hyundai manuals:

Removal, installation and testing of the power transistor Hyundai Accent 3 (2005-2010)
Coolant Temperature Sensor — Removal, Installation and Testing Hyundai Elantra 1 (1990-1995, petrol)
Location and testing of relays Hyundai Getz (2002-2011)
Checking the power steering belt tension Hyundai Sonata 3 (1993-1998)
Checking the fluid level in the power steering reservoir Hyundai Santa Fe 2 (2007-2012, petrol)
Checking the fluid level in the power steering reservoir Hyundai Matrix (2001-2010, petrol)

Link in different formats to this article

TextHTMLBB Code

Visitor comments

No comments yet