Troubleshooting the bodywork (Hyundai Elantra XD)

Sign	Probable cause	Method of elimination
The roof hatch is leaking	The drain hoses are clogged with dirt	Clean the drain hoses
	The drain hose is clogged	Blow air through the drain hose
	The drain hose is damaged or the hose clamp is defective	Check the condition of the hose and clamp
	The hatch seal is damaged	Replace the seal
	Large gap between the cover and the hatch body	Adjust the position of the hatch cover
The sound of the wind	The deflectors are not properly secured or are damaged	Tighten or replace deflectors
Noise when moving the hatch cover	Foreign particles in the hatch guides	Check the drive cable and sunroof guides for foreign particles
Noise when moving the hatch cover	The guides and/or the hatch cover are not tightened	Tighten it up
The sunroof drive motor works, but the sunroof does not move or moves only slightly	Foreign particles in the hatch guides	Check the drive cable and sunroof guides for foreign particles
	Incorrect engagement of engine gear with drive cable	Check the gear engagement for reliability and absence of gear damage
	Reducing friction in the engine clutch	Adjust
	Increased sliding resistance of hatch, cables or seal	Adjust or replace
Engine noise when sunroof is fully closed or open	Incorrect engagement of engine gear with drive cable	Check the gear engagement and re-tighten the motor
	The pinion bearing is worn or damaged	Replace
	The drive cable is worn or damaged	Replace
The door glass does not go down	Incorrect installation of window glass	Adjust the position of the window glass
The door glass does not go down	The window regulator is damaged	Repair or replace the window regulator
Doors do not open or close completely	Incorrect door installation	Adjust the door position
	The door opening limiter is not installed correctly	Replace or install correctly
	The door hinges are not lubricated	Lubricate the door hinges
The hood does not open or closes completely	The strike plate and latch are not adjusted properly	Adjust the position of the strike plate and latch
	The hood is not installed correctly	Adjust the position of the hood
	The hood stop height is set incorrectly	Adjust the position of the hood stop
Water passes through the windshield and rear window	The glass seal is damaged	Replace the glass seal