Cardan shaft — checking the technical condition (Hyundai Tucson JM)

1. Install a dial indicator. Align the indicator needle with the center of the cardan shaft.

2. Slowly turn the cardan shaft. Measure the runout. The maximum permissible value of the cardan shaft runout is 0.3 mm.

2. Slowly turn the cardan shaft. Measure the runout. The maximum permissible…

3. If the runout value exceeds the permissible value, the cardan shaft must be replaced.

[The original can be read on the resource: HYUNDAIBOOK.RU]

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This article has been reviewed by: Konstantin Smirnov

Add to social network:

Tucson 1: Drive shafts and cardan

Cardan shaft — device
Rear axle — installation
Rear axle — assembly
Rear axle — disassembly
Rear axle — technical condition check

Cardan shaft — removal and installation
Rear gearbox — device
Rear gearbox — removal
Rear gearbox — technical condition check
Rear gearbox — installation

We recommend other articles on the topic of Hyundai manuals:

Checking the condition of the drive shaft boots Hyundai Accent 3 (2005-2010)
Checking the suspension and condition of the exhaust tract Hyundai Elantra 1 (1990-1995, petrol)
Checking the technical condition and operability of the brake… Hyundai Getz (2002-2011)
Checking tire pressure and condition Hyundai Sonata 4 (2001-2012, petrol)
Table 3.21. Technical characteristics of the cardan shaft Hyundai Santa Fe 2 (2007-2012, petrol)
Checking the technical condition of the car Hyundai Matrix (2001-2010, petrol)

Link in different formats to this article

TextHTMLBB Code

Visitor comments

No comments yet