Engine bay harnesses (ENGINE HARNESS)
Purpose of harness connectors:
- E01, E02 - Generator (Generator)
- E03, E04 - Outside air temperature sensors No.1 + No.2 (Ambient Sensor #1, #2)
- E08 - A/C Pressure Transducer (A/C Pressure Transducer)
- E10 - Alarm siren (Burglar Alarm Horn)
- E11 - Brake fluid level sensor (Brake Fluid Level Sensor)
- E13 - Air conditioning radiator fan motor (Condenser Fan Motor)
- E14 - Resistor in DRL system (DRL Resistor)
- E15 - Front impact sensor (right) (Passenger Front Impact Sensor)
- E16 - Multifunctional test socket (Multipurpose Check Connector)
- E18 - Front impact sensor (left) (Driver Front Impact Sensor)
- E19 - Front right fog lamp (Front Fog Lamp RH)
- E20 - Front left fog lamp (Front Fog Lamp LH)
- E21 - Windscreen wiper motor (Front Wiper Motor)
- E24 - Bonnet Limit Switch (Hood Switch)
- E25 - Beeper (Horn)
- E26 - Block-Lara left (Head Lamp LH)
- E27 - Right headlight (Head Lamp RH)
- E28 - Ignition switch limit switch (Ignition Lock Switch)
- E37 - Electric motor of the radiator fan of the engine cooling system. (Cooling Fan Motor)
- E39 - Brake light switch (Stop Lamp Switch)
- E44 - Left turn signal lamp (Turn Signal Lamp LH)
- E45 - Right turn signal lamp (Turn Signal Lamp RH)
- E48 - Windscreen and rear window washer pump electric motor (Front & Rear Washer Motor)
- E49 - Front left wheel speed sensor (Front Wheel Sensor LH)
- E50 - Front right wheel speed sensor (Front Wheel Sensor RH)
- E51 - ABS control unit (ABS Control Module)
- E53 - (Power Steering Switch)
- E61 - Heater Fan Relay (Blower Relay)
- E62 - Horn relay (Horn Relay)
- E63 - Main relay (Main Relay)
- E64 - Starter relay (Start Relay)
- E65 - Relay #1 of the air conditioner radiator fan (Condenser Fan Relay #1)
- E66 - Air Conditioner Relay (A/Con Relay)
- 1E67 - Fuel pump relay (Fuel Pump Relay)
- E68 - Radiator fan relay for cooling system (Radiator Fan Relay)
- E69 - Relay #2 of the air conditioner radiator fan (Condenser Fan Relay #2)
- E70 - Fuel pump test connector (Fuel Pump Check Connector)
- EC01-EC03 - Connection to control harnesses (Connection With CONTROL Harness)
- EE01 - Connection to battery harnesses (Connection With BATTERY Harness)
- EF01 - Connection with floor harnesses (Connection With FLOOR Harness)
- EM01, EM02 - Connection to main harnesses (Connection With MAIN Harness)
- l/PD, l/PE, l/PF - Connection to the switching unit (Connection With l/P JUNCTION BOX Harness)
- G12-G16 - Connection to ground (Ground)
Control system harnesses (CONTROL HARNESS)
Purpose of harness connectors:
Control system harnesses (CONTROL HARNESS):
- C01 - Manual transmission control unit (ECM (M/T))
- C01-1 - Automatic transmission control unit (ECM (K) (ALU)
- C01-2 - Automatic transmission control unit (PCM (A)(A/T))
- C02 - Air Conditioning Compressor (A/C Compressor)
- C03 - Inlet Air Mass Sensor (Mass Air Flow Sensor)
- C05 - Camshaft Position Sensor (Camshaft Position Sensor)
- C06 - Crankshaft position sensor (Crankshaft Position Sensor)
- C07 - Capacitor (Condenser)
- C08 - Electromagnetic valve for controlling the timing phase regulator (CVVT Oil Control Valve)
- C09 - Engine idle speed control actuator (Idle Speed Control Actuator)
- C11 - Automatic transmission position switch (engine start inhibition) (Transaxle Range Switch)
- C12 - Switching connector (Joint Connector)
- C13-1 - Injector No.1 (Injector #1)
- C14 - Knock sensor (Knock Sensor)
- C15 - Kick Down Mode Switch (Automatic Transmission) (Kick Down Switch (A/T))
- C17 - Oxygen sensor, upper (Oxygen Sensor (Up))
- C18 - Oxygen sensor, lower (Oxygen Sensor (Down))
- C19 - Oil temperature sensor (automatic transmission) (Oil Temperature Sensor (A/T))
- C20 - Pulse Generator "A" (automatic transmission) (Pulse Generator A')
- C21 - Pulse Generator "B" (automatic transmission) (Pulse Generator'B)
- C22 - Vehicle speed sensor (automatic transmission) (Vehicle Speed Sensor (A/T))
- C23 - Throttle Position Sensor (Throttle Position Sensor)
- C24 - Electromagnetic valve block (automatic transmission) (ATM Solenoid Valve)
- CC01 - Connection to ignition coil wiring (Connection With IGNITION COIL EXTENSION Hamess)
- CC02 - Connection to injector wiring (Connection With INJECTOR Harness)
- CC03 - Connection to manual transmission wiring (Connection With MTM EXTENSION Harness)
- EC01-EC03 - Connection to harnesses in the engine compartment (Connection With FRONT Harness)
- G18 - G20 - Connection to ground (Ground)
Ignition Coil Wiring (IGNITION COIL EXTENSTION HARNESS):
- C10-1 + C10-4 - Ignition coils #1 + #4 (Ignition Coil#1+#4)
- CC01 - Connection to control harnesses (Connection With CONTROL Harness)
Wiring of injectors (INJECTOR HARNESS):
- C13-2-C13-4 Injectors N°2 + N°4 (Injector #2 + #4)
- C26 - Solenoid valve for gasoline vapor absorber (Purge Control Solenoid Valve)
- C27 - Coolant temperature sensor (Engine Coolant Temperature Sensor & sender)
- CC02 - Connection to control harnesses (Connection With CONTROL Harness)
Manual transmission wiring (MTM EXTENSION HARNESS):
- C04 - Reverse lamp limit switch (Back-up Lamp Switch)
- C22 - Vehicle Speed Sensor (MT)
- CC03 - Connection to control harnesses (Connection With CONTROL Harness)