Checking the technical condition
1. Turn off the ignition.
2. Disconnect the EGR cooler bypass solenoid valve connector.
3. Measure the resistance between terminals 1 and 2 of the valve.
4. Check that the resistance matches the specification.
Removal
1. Turn the ignition key to the "OFF" position and disconnect the negative (-) cable from the battery.
The original can be read on the resource (HyundaiBook)
2. Disconnect the EGR cooler bypass solenoid valve connector (A).
3. Disconnect the vacuum hose (B) from the EGR cooler bypass solenoid valve.
4. Loosen the mounting bolt and remove the valve (C).
Installation
Attention.
- Tighten the component mounting bolts to the specified torque.
- Be careful not to drop the component. If dropped, the component must be carefully checked before installation.
Installation is performed in the reverse order of removal.
Note: Tightening torque: EGR cooler bypass solenoid valve mounting bolt: 7.8 - 11.8 Nm.