Checking the technical condition of the headlight relay (Hyundai Tucson JM)

1. Remove the headlight relay (A) low beam and (B) high beam from the engine compartment relay block.

2. Apply voltage to contacts 3 and 4. Check the continuity of the circuit between contacts 1 and 2. If there is no circuit, the relay must be replaced.

The original version is stored on the website HYUNDAIBOOK.ru

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This article has been reviewed by: Konstantin Smirnov

Add to social network:

Tucson 1: Equipment and devices

Headlights — Removal and Installation
Lighting system — device
Mirror system
Instrument panel — checking the technical condition
Instrument panel — removal and installation

Turn signal lamps — removal and installation
Interior lighting — removal and installation
Interior lighting — checking the technical condition
Turn signal and hazard warning lights — checking technical condition
Lighting system circuit breaker — technical condition check

We recommend other articles on the topic of Hyundai manuals:

Checking the condition of the exhaust system Hyundai Accent 3 (2005-2010)
Checking the headlight relay Hyundai Elantra 3 (2000-2006)
Checking the technical condition and operability of the brake… Hyundai Getz (2002-2011)
Checking tire pressure and condition Hyundai Sonata 4 (2001-2012, petrol)
Table 2.16. Checking the Fan Relay Circuit Hyundai Santa Fe 2 (2007-2012, petrol)
Checking the technical condition of the car Hyundai Matrix (2001-2010, petrol)

Link in different formats to this article

TextHTMLBB Code

Visitor comments

No comments yet