Bleeding the brake system
1. Make sure that the brake fluid level in the expansion tank is at the MAX mark (A).
2. Attach a vinyl hose to the bleed nipple on the wheel cylinder, lower the other end of the hose into a container with brake fluid.
3. Start the engine.
4. Press the brake pedal several times.
5. With the pedal pressed all the way down, loosen the bleed nipple until brake fluid begins to flow out, then tighten the nipple.
6. Repeat steps 4 and 5 until there are no air bubbles in the flowing liquid.
7. Tighten the air bleed nipple.
8. Perform the specified operations on the remaining wheels in the order shown in the figure.
