2. Using a special device, compress the spring.
Note: Painted identification marks on the rack parts must be identical.
3. Pull the shock absorber rod out completely, then install the upper spring support and insulator.
4. After the spring (A) has seated itself in the supports (B) as shown in the figure, screw on a new self-locking nut.
5. Remove the special device from the spring.
6. Tighten the self-locking nut. The tightening torque of the nut is 40-60 Nm.
7. Apply lubricant to the upper strut bearing, then install the insulator cover.
