Brake light bulbs — removal and installation (Hyundai Tucson JM)

1. Disconnect the negative battery terminal.

2. Open the rear door, remove the cover (A).

3. Loosen the two nuts, disconnect the connector (B) and remove the turn signal lamp.

4. Installation is carried out in the reverse order of removal.

Information is taken from a thematic website www.hyundaibook.ru

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This article has been reviewed by: Konstantin Smirnov

Add to social network:

Tucson 1: Equipment and devices

Fog light switch
Checking the technical condition of the front fog light relay
Front fog lights — removal and installation
Lighting system circuit breaker — technical condition check
Turn signal and hazard warning lights — checking technical condition

Automatic lighting system — device
Automatic Lighting System — Schematic Diagram
Automatic lighting control unit — checking the technical condition
Adjusting the direction of the headlights

We recommend other articles on the topic of Hyundai manuals:

Brake light electrical diagram Hyundai Accent 1 (1994-1999)
Brake pad wear warning light Hyundai Elantra 3 (2000-2006)
High-mounted brake light Hyundai Getz (2002-2011)
Brake light — diagram Hyundai Sonata 3 (1993-1998)
High-mounted brake light Hyundai Santa Fe 2 (2007-2012, petrol)
High-mounted brake light Hyundai Matrix (2001-2010, petrol)

Link in different formats to this article

TextHTMLBB Code

Visitor comments

No comments yet