Stretcher: 1 - transverse stabilizer bar; 2 – rear balance beam support bracket for engine mount; 3 – subframe; 4 – suspension arm.
Removal
Loosen the bolts securing the suspension arm silent blocks.
Muffler inlet pipe
Remove the exhaust pipe.
Engine mount balance beam support bracket
The article is borrowed from the website (www.hyundaibook.ru)
Remove the rear engine mount balance beam bracket.
To make it easier to remove the subframe, unscrew the steering gear mounting bolts and the stabilizer strut ball joint mounting nuts, hang the steering gear and steering rods from the engine.
Installing a jack under the subframe
Place a jack under the subframe and remove the subframe by unscrewing the bolts securing it to the body.
Checking the technical condition
Check the subframe for cracks or deformation.
Check suspension mounts and silent blocks for cracks or deterioration of material properties.
Installation
Install the subframe, supporting it with a jack.
Install the steering gear and anti-roll bar.
Tighten the bolts and nuts securing the suspension arm silent blocks.
Install the rear engine mount balance beam bracket.
Install the exhaust pipe.