Contents: Removal ⇓ Installation ⇓
Front suspension arm: 1 – transverse stabilizer bar; 2 – brake disc; 3 – steering rod; 4 – suspension arm; 5 – subframe; 6 - crossbar stabilizer bar
Removal
Remove the front wheel.
Pressing out the ball joint pin of the steering rod end from the steering knuckle
Press the ball joint pin of the tie rod end out of the steering knuckle using puller 09568-34000.
Pressing out the ball joint pin from the steering knuckle
Press the ball joint out of the suspension arm using puller 09568-34000.
Loosen the bolts securing the suspension strut to the steering knuckle.
Suspension arm silent blocks: 1 – silent block A; 2 – silent block G; 3 – subframe; 4 – suspension arm
Loosen the bolts securing the silent blocks A and G of the suspension arm.
Remove the suspension arm.
Installation
The suspension arm is installed in the reverse order of removal.
[The material is reprinted from another resource: www.hyundaibook.ru]
Tighten the threaded connections to the torques specified below.
Tightening torque, Nm:
- Wheel nuts - 90-100
- Suspension arm ball joint pin mounting nut — 60–72
- Silent block mounting bolt A - 95–120
- Silent block mounting bolt G - 130–150
- Nuts for fastening the ball joint pins of the stabilizer bar — 35–45