Contents: Removal ⇓ Installation ⇓
Telescopic front suspension strut
Removal
Remove the front wheel.
Without using excessive force, disconnect the brake hose holder and wheel speed sensor connector from the suspension strut.
Remove the windshield wiper and air intake cover.
Upper strut support mounting nuts
Loosen the bolts securing the upper support of the suspension strut.
Suspension strut to steering knuckle mounting nuts
Remove the front suspension strut assembly.
Installation
When installing the stand, make sure that no foreign objects get between the supporting surfaces.
Anti-roll bar: 1 – transverse stabilizer bar; 2 – brake hose; 3-pin connector of the wheel speed sensor
[The original source of the article is the website: hyundaibook]
Connect the brake hose, wheel speed sensor connector and stabilizer bar strut.
Tighten the threaded connections to the torques specified below.
Tightening torques, Nm:
- Upper strut support mounting nut — 20–30
- Nuts for mounting bolts of suspension strut to steering knuckle — 110–130
- Nuts for fastening the ball joint pins of the stabilizer bar — 35–45