Pic. 4.15. A-pillar assembly
Withdrawal
Remove the front wheel.
Pic. 4.16. brake hose bracket
Disconnect the brake hose bracket from the A-pillar assembly on models with ABS, remove the wheel speed sensor from the steering knuckle and disconnect the sensor wire from the A-pillar (pic. 4.16).
Note. Do not apply excessive force when detaching parts.
Pic. 4.17. Nuts of fastening of a damping support of a forward rack
Loosen the three nuts securing the front strut damping mount (upper) (pic. 4.17).
Pic. 4.18. Bolts of fastening of a forward rack to a rotary fist
Loosen the bolts securing the front strut to the steering knuckle (lower) and remove the stand assembly (pic. 4.18).
Installation
Before installing the A-pillar assembly, make sure the connecting surfaces of the parts are clean.
Tighten the parts listed below to the following torque ratings.
Connect the brake hose bracket to the A-pillar On models with ABS, install the wheel speed sensor on the steering knuckle and connect the sensor wire to the A-pillar.