Note: When disconnecting the ignition wire, hold it by the cap. If you disconnect it by pulling directly on the wire, the integrity of the circuit may be compromised.
Replacing ignition wires (Hyundai Sonata Y3)
0
Spark plug wires should be replaced with new ones periodically. After replacement, make sure that the spark plug wires and clamps are connected correctly and securely.
This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
Previous
Next
We recommend other articles on the topic of Hyundai manuals:
Replacing the air filter Hyundai Accent 1 (1994-1999)
Replacing ignition wires Hyundai Elantra 2 (1995-2000, petrol)
Combination ignition switch Hyundai Getz (2002-2011)
Combination ignition switch Hyundai Santa Fe 2 (2007-2012, petrol)
Ignition switch with illumination (additional equipment) Hyundai Tucson 1 (2005-2010)
Checking and replacing fuses Hyundai Matrix (2001-2010, petrol)
Link in different formats to this article
Visitor comments
No comments yet
- General information
- User manual
- Maintenance
- Power unit
- 2.0 and 2.4 liter engines
- 2.7 liter engines
- Engine overhaul
- Cooling system
- Intake and exhaust systems
- Lubrication system
- MFI fuel injection system
- Engine electrical equipment
- Transmission
- Clutch
- Mechanical gearbox
- Automatic gearbox
- Drive shafts
- Chassis
- Front suspension
- Rear suspension
- Steering
- Brake system
- Body
- Exterior
- Interior
- Heater and air conditioner
- Security systems
- Electrical equipment
- Troubleshooting
- Electrical circuits
- General information
- Maintenance
- Power unit
- Engine repair I4 DOHC
- Engine repair I4 SOHC
- Engine repair V6 SOHC
- Cooling system
- Intake and exhaust system
- Exhaust gas treatment
- Fuel system
- Transmission
- Clutch
- Mechanical gearbox
- Automatic transmission KM-175
- Automatic transmission F4A33
- Chassis
- Front suspension
- Rear suspension
- Steering
- Brake system
- Body
- Body elements
- Electrical equipment
- Equipment and devices