Collapse
- Standard value - -30'±30'
To perform adjustment operations, loosen the tightening of the lower rod mounting bolt.
Note: The auxiliary rod mounting bolt (on the cross member side) must be loosened a few turns when making adjustments.
The accuracy of measurements is approximately 15'.
Convergence
- Standard value: from 3 to -2 mm
Note: The auxiliary rod mounting bolt (on the cross member side) must be turned an equal angle in both directions when performing adjustment operations.
Checking the axial clearance in the wheel bearing
1. Check the axial clearances in the bearings when the vehicle is raised on a jack.
2. If any amount of axial clearance is detected, remove the cap and release the parking brake.
3. Remove the bracket assembly and brake disc.
4. Check the axial play of the bearing. Place a dial gauge on the surface of the wheel hub, and then move the hub axially and check for axial play.
- The maximum axial clearance is 0.01 mm or less
5. If the result exceeds the limit value, the rear wheel bearing nut should be tightened to the specified torque value, after which the axial play is checked again.
6. If the adjustment fails to select this gap, the entire rear wheel hub bearing should be replaced.