1. Before connecting the valve to the container, turn the handle fully counterclockwise.
2. Turn the handle counterclockwise until it reaches the highest position.
3. Connect the central hose with the valve nipple. Turn the handle clockwise until it stops.
4. Turn the handle clockwise to punch a hole in the sealed cap at the top of the can.
5. Loosen the nuts of the central hose connected to the pressure gauge fitting.
6. Release air for a few seconds and tighten the nut.
Connecting the inlet valve to the refrigerant cylinder (Hyundai Getz 1)
0
This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
Previous
Next
We recommend other articles on the topic of Hyundai manuals:
Cylinder head — removal, inspection and installation Hyundai Accent 1 (1994-1999)
Connecting the outlet valve to the refrigerant cylinder Hyundai Elantra 3 (2000-2006)
Cylinder Heads, Valves and Valve Springs — Removal and… Hyundai Sonata 3 (1993-1998)
Socket for connecting additional equipment Hyundai Santa Fe 2 (2007-2012, petrol)
Checking and adjusting valve clearances Hyundai Tucson 1 (2005-2010)
Checking the cylinder block Hyundai Matrix (2001-2010, petrol)
Link in different formats to this article
Visitor comments
No comments yet
- User manual
- Control devices
- Heating and ventilation
- Audio system
- Car driving
- Faults en route
- Maintenance
- Technical information
- Power unit
- Engine repair 1.1/1.3 l
- Engine repair 1.5/1.6 l
- Lubrication system
- Cooling system
- Fuel system
- Exhaust system
- Ignition system
- Transmission
- Clutch
- Mechanical gearbox
- Automatic gearbox
- Drive shafts and axles
- Chassis
- Suspension and wheels
- Steering
- Brake system
- Body
- Exterior (external elements)
- Interior (internal elements)
- Air conditioning and heater
- Electrical equipment
- Equipment and devices
- Power devices
- Electrical circuits