Removal and installation
1. To remove the sunroof assembly, remove the following parts:
- front seats;
- back seat;
- roof console;
- front pillar trims;
- upholstery of thresholds of front and rear doors;
- front seat belts;
- lower and upper trims of the middle pillars;
- rear seat belt fastening;
- cross-facing;
- middle seat belt fastening;
- -side trims of the luggage compartment;
- rear pillar trims;
- sun visors and handrails;
- roof lining.
2. Disconnect the drain hose
Tightening torque: 4–6 Nm
3. Installation is carried out in the reverse order of removal.
Dismantling the hatch
1. Unscrew the three nuts securing the electric motor, disconnect the connector from the control unit and remove the electric motor.
4. Remove the stopper at the end of the sled and remove the sunshade.
5. Use a screwdriver to press the slider and turn the guide, manually pressing the lock up through the hole on the reverse side
6. Remove two screws on the left and right sides and remove the deflector.
4. Place the "A" pad on top and the "B" pad on the bottom.
8. Install the sunshade and insert the stopper.
Attention! When installing the curtain, check the reliability of the protective caps.
Note: Initialization must be performed in the following cases:
After opening or closing the hatch manually.
After replacing parts, including the electric motor, control unit and wires.
After troubleshooting the hatch wiring.
In case of malfunction after replacing the battery
Emergency closing is carried out when the sunroof electric drive or control unit fails, for example when it starts to rain, when driving on the highway, etc.
With the hatch closed, insert the Allen key into the motor shaft socket and turn it clockwise.