Withdrawal
Remove the gearbox and clutch.
Remove flywheel.
Pic. 2.70. Flywheel and torque converter drive plate
Examination
Check the condition of the contact surface of the flywheel with the clutch disc (no uneven wear or damage). Replace the flywheel if the surface is damaged or has significant wear.
Measure the runout of the contact surface of the flywheel with the clutch disc.
Flywheel runout rating: 0.1 mm.
Check the condition of the flywheel ring gear (no damage, cracks or significant wear) and replace it if necessary.
Installation
Install the flywheel assembly and tighten the mounting bolts to the specified torque.
Flywheel tightening torque: 120–130 Nm.