Pic. 1.192. Removing the mounting bolt cover
To remove the spare wheel, open the rear door. Remove the fixing bolt cover with a screwdriver or a coin (pic. 1.192
Pic. 1.193. Loosening the spare wheel nut
Loosen the spare wheel nut with a wheelbrace until the spare wheel is lowered to the ground (pic. 1.193).
Pic. 1.194. Removing the holder
Pull the spare wheel out from under the car and remove the holder in the center of the wheel rim (pic. 1.194).
Spare wheel installation
Lay the spare wheel on the ground with the valve up.
Slide the spare wheel under the vehicle and position the holder in the center of the wheel rim.
Align the holder with the holes in the disc for the wheel nuts.
Use a balloon wrench to tighten the spare wheel nut until it clicks into place.
Install the fixing bolt cover with a screwdriver or a coin.
Note. Stop tightening the spare wheel fastener after one or two clicks.