Checking the pull-in winding of the traction relay (Mitsubishi Matrix)

Disconnect the stator winding wire from the "M" terminal of the traction relay.



Connect the wires from the 12 V terminals of the battery to the terminals "S" (+) and "M" (–) of the traction relay (Fig. 7.58).

Attention! This check must be carried out quickly, no more than 10 seconds, to prevent burnout of the starter winding.

Attention! If the drive pinion extends, then the pull-in winding of the traction relay is in good condition. If the drive pinion does not extend, replace the traction relay.