Contents: Removal ⇓ Installation ⇓
Removal
1. Jack up the car, unscrew the bolts and remove the rear wheel.
- Tightening torque: 90-110 Nm
2. Loosen the rear rod bolt and remove the nut and washer.
- Tightening torque: 100-120 Nm
3. Loosen the nut of the front rod bolt, remove the washers and take out the bolt.
- Tightening torque: 140-100 Nm
4. Remove the rear suspension longitudinal rod.
5. Using special tools, press the bushing out of the rod.
Installation
1. Installation of the rear suspension longitudinal rod is carried out in the reverse order of removal; the tightening torques of the bolts and nuts are indicated in the text describing the removal procedure and in the assembly drawing "Rear suspension arms and rods".
2. When installing the bushing, apply soapy water to it and place it as shown in the figure.
