Contents: Removal ⇓ Installation ⇓
Removal
1. Jack up the car, unscrew the bolts and remove the rear wheel.
- Tightening torque: 90-110 Nm
2. Unscrew the rod mounting nuts, remove the washers, remove the bolts and remove the longitudinal rod.
Tightening torque of rod mounting nuts:
- to the fist: 80-100 Nm
- to subframe: 100-120 Nm
3. Using a special tool, press the bushing out of the rod.
Installation
1. Installation of the rear suspension crossbar is carried out in the reverse order of removal, the tightening torques of the bolts and nuts are indicated in the text of the description of the removal procedure and in the assembly drawing "Rear suspension arms and rods".
2. When installing the bushing, apply soapy water to the mating surfaces of the bushing and rod as shown in the figure.
