Attention! On vehicles equipped with engines with a catalytic converter, it is necessary to ensure that the oil level on the dipstick is not above the maximum mark. If too much oil has been poured into a car with a catalytic converter, the excess must be removed from the crankcase by draining or suction (special vacuum pump), otherwise unburnt oil will enter the exhaust system and may destroy the catalytic converter.
Start the engine and warm it up to operating temperature.
Stop the engine.
Remove the oil filler cap and remove the oil pan drain plug. Drain the engine oil.
Install and tighten the drain plug to the specified torque.
Drain plug tightening torque: 35–45 Nm.
Note. Do not reinstall the sealing washer under the plug.
Fill the engine with fresh engine oil through the oil filler neck.
Refueling capacity without changing the oil filter - 4.5 liters.
Attention! Do not fill the engine oil above the maximum level. This will aerate the oil and reduce oil pressure.
Install the oil filler cap.
Start the engine and let it run.
Stop the engine and check the engine oil level. Add oil if necessary.