Contents: Removal ⇓ Installation ⇓
Removal
Remove the drain plug and drain the oil from the gearbox.
Remove the clutch slave cylinder.
Remove the air filter housing assembly.
Remove the battery and its tray.
Fig. 3.37. Speedometer drive cable
Disconnect the gear selector cable and the gear shift cable (Fig. 3.37).
Fig. 3.38. Reverse light switch connector
Disconnect the reversing light switch connector (Fig. 3.38).
Disconnect the speedometer drive cable.
Disconnect the clutch cable or clutch hydraulic pipe.
Remove the lower engine cover and the gearbox side cover.
Remove the front and rear engine mounts as an assembly.
Remove the left and right front wheels as an assembly.
Loosen the bolt securing the front suspension strut to the steering knuckle.
Remove the wheel drive shafts.
Fig. 3.39. Removing the starter
Remove the starter (Fig. 3.39).
Fig. 3.40. Fastening the engine to a special device
Secure the engine to a special device (crossbar 09200-38001) using the mounting brackets (Fig. 3.40).
Remove the gearbox support (left).
Remove the upper gearbox mounting bolt.
Fig. 3.41. Fastening the protective crankcase cover
The original text is published on the website [HyundaiBook.ru]
Remove the protective cover of the gearbox housing (Fig. 3.41).
Install a transmission telescopic stand (T/M Jack) under the gearbox.
Remove the lower gearbox mounting bolt.
Remove the clutch housing and clutch driven disc.
Remove the flywheel.
Remove the gearbox.
Installation
Installation of parts is carried out in the reverse order of removal.