Withdrawal
Note. Do not disassemble or repair the airbag module.
Note. Do not drop the unit, do not allow the module to be contaminated with water, oil or grease. Replace the module if it is dented, cracked, deformed, or rusted.
Note. The cushion module should be stored on a flat surface with the pad facing up. Do not place any objects on the pillow cover.
Note. Do not allow airbag module to heat up above 93°C.
Note. Undermining and disposal of the pillow must be carried out according to a special procedure.
Note. Never try to measure the ignition resistance of a pillow, even with a special tester: the pillow may suddenly explode, which will lead to an accident.
Note. If the airbag has deployed, the airbag module must be replaced with a new one.
Disconnect the wire from the negative battery terminal.
Attention! Before starting work, pause for at least 30 seconds.
Remove the glove box.
Disconnect the passenger airbag module connector.
Remove the front panel and remove the passenger airbag module.
The upholstery of the passenger airbag module is integrated with the upholstery of the front panel. Therefore, in case of undermining the pillow, the front panel must be replaced.