Note: When bleeding with pressurized fluid, do not press the brake pedal back down.
2. Connect the PVC tube to the threaded connection of the wheel cylinder bleeder valve and place the other end of the tube in a half-filled container of brake fluid.
3. Slowly press the brake pedal several times.
4. When you fully press the brake pedal, fluid starts to come out through the bleed valve. Then close the bleed valve.
5. Repeat steps 3 and 4 until no more bubbles appear in the liquid.
6. Tighten the threaded plug with the hole.
[The text is taken from an online source: HyundaiBook]
Tightening torque of the threaded plug:
- Front: 7-13 Nm
- Rear: 8-20 Nm
7. Repeat the above procedure for each wheel in the sequence shown in the figure.
