Replacing the crossmember bushing
1. Use the special tool to remove and press bushings A and B.
2. Press bushings A and B so that the inner sleeve comes out.
Standard size:
- Bushing A - 9.2-10.2 mm
- Sleeve B - 8.5-9.5 mm
Warning: When pressing, use soapy water to loosen the bushings and then press them one by one.
The original text is published on the website: www.hyundaibook.ru
 |
 |
Installation
1. Install the front end of the center beam so that the bushings are positioned as shown in Fig.
