Table 2.49. Checking the adsorber using the HI-SCAN (PRO) tester (Hyundai Santa Fe CM)

0

Checking the adsorber using the HI-SCAN (PRO) tester

Parameter to be checked	Conditions for conducting the inspection	Data (tester readings)	Normal condition
Solenoid valve for adsorber development - Checking actuators (ACTUATOR TEST)	Ignition switch is in the ON position (Engine not running)	Canister Purge Solenoid Valve (PCSV)	Activated (Activate)

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This article has been reviewed by: Konstantin Smirnov

Add to social network:

Previous

Santa Fe 2: Engine specifications

Next

Table 2.48. Tested parameter of injector operation
Table 2.47. Checking with the HI-SCAN (PRO) tester
Table 2.46. Tested parameter of injector operation
Table 2.45. Checking with the HI-SCAN (PRO) tester
Table 2.44. When using a diagnostic device of the GST type

Table 2.50. Checking the sensor using the HI-SCAN (PRO) tester
Table 2.51. Fuel pressure test conditions
Table 2.52. System status, possible causes of malfunction and methods of their elimination
Table 2.53. Diagnostic parameters
Table 2.54. Troubleshooting Guide

We recommend other articles on the topic of Hyundai manuals:

Checking the gearbox oil level Hyundai Accent 1 (1994-1999)
2.0L Engine Timing Belt — Checking Tension/Adjusting Hyundai Elantra 1 (1990-1995, petrol)
Checking engine oil Hyundai Getz (2002-2011)
Checking the purge solenoid valve of the adsorber Hyundai Sonata 4 (2001-2012, petrol)
Checking and adjusting valve clearances Hyundai Tucson 1 (2005-2010)
Table 2.25. Checking with a tester Hyundai Matrix (2001-2010, petrol)

Link in different formats to this article

TextHTMLBB Code

Visitor comments

No comments yet

Santa Fe 2 (2007-2012, petrol)

This site uses cookies to optimize its functionality. By continuing, you agree to our terms.