Table 2.39. Checking with the HI-SCAN (PRO) tester (Hyundai Santa Fe CM)

0

Checking with the HI-SCAN (PRO) tester

Component under test	Conditions for conducting the inspection	Data (tester readings)	Nominal state
Idle speed control servo - Checking actuators (ACTUATOR TEST)	Starting the engine	Idle speed control servo	Activated (Activate) Result: Engine speed should increase or decrease

(The full version is located on the website: www.hyundaibook.ru)

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This article has been reviewed by: Konstantin Smirnov

Add to social network:

Previous

Santa Fe 2: Engine specifications

Next

Table 2.38. Checking with the HI-SCAN (PRO) tester
Table 2.37. Checking with a multimeter
Table 2.36. Checking with the HI-SCAN (PRO) tester
Table 2.35. Air flow sensor component to be tested (MAF 2.7 V6)
Table 2.34. Checked parameter of the mass air flow (MAF) sensor and the intake manifold air temperature (IAT) sensor

Table 2.40. Oxygen sensor with heater parameter to be tested
Table 2.41. Output voltage of the oxygen sensor with heater
Table 2.42. When using a diagnostic tool of the GTS type
Table 2.43. Oxygen sensor output voltage
Table 2.44. When using a diagnostic device of the GST type

We recommend other articles on the topic of Hyundai manuals:

Checking the gearbox oil level Hyundai Accent 1 (1994-1999)
2.0L Engine Timing Belt — Checking Tension/Adjusting Hyundai Elantra 1 (1990-1995, petrol)
Checking engine oil Hyundai Getz (2002-2011)
Checking the engine oil level Hyundai Sonata 3 (1993-1998)
Checking and adjusting valve clearances Hyundai Tucson 1 (2005-2010)
Table 2.25. Checking with a tester Hyundai Matrix (2001-2010, petrol)

Link in different formats to this article

TextHTMLBB Code

Visitor comments

No comments yet

Santa Fe 2 (2007-2012, petrol)

This site uses cookies to optimize its functionality. By continuing, you agree to our terms.